PP Melt Blown Filter Cartridge-MG Series is fusing and intertwined of polypropylene resin without any chemical glues.The cartridges are glued at random to form 3D micro pore which will make the cartridge 3 layers with fine fibers in surface and coarse fibers and deep filtration. As the fiber and density form high filtration rating and pollutants holding capacity on diameter of filter cartridge, low pressure drop, gradual changing deep filtration structure with loose outside and close inner, strong pollutants holding capacity, it can remove contaminant effectively, such as suspended substance, particulate and rust, providing efficient filtration and long service life.Mini grooved surface increases the surface area and make the cartridge has a better appearance.
■Drinking Water Treatment
■Food and beverage
■Industrial Water Treatment
Three layers structure cartridge offers high dirt holding capacity,longer service life Formed by thermal bond without using any binders and adhesives.
100% Pure Polypropylene will not cause any pollution to water Wide Chemical compatibility
Mini groove design to extend the filtration surface area.
All kinds of adaptors are available.
FDA compliance material
Dimensions: Outside Diameter: 63mm
Inside Diameter: 28mm,30mm Length: 9.75〃,9.87",10n ,20" ,30" ,40"
Material of Constructions: Filter media: PP
End caps: PP Cores: PP
Gaskets/O-ring: Silicone, EPDM, NBR, Viton
Performance: Removal Rating: 1,3,5,10,25(jm
Maximum Differential Pressure: 2.0 bar @ 21 *C Maximum Operating Temperature: 65 *C
Part Numbers/Ordering Information